Contractor field notesHow This Calculator WorksFormula, worked example, assumptions, common pitfalls, and FAQs
Work out a uniform straight stair before detailed design
This planning calculator divides a total rise into uniform risers using your preferred maximum height. It assumes a straight stair ending at an upper landing, so tread count is normally one less than riser count. Custom checks compare only the limits you enter; they are not jurisdiction-specific code approval.
Straight-stair geometry
Risers = ceiling(total rise ÷ preferred maximum riser). Actual riser = total rise ÷ risers. Treads = risers − 1. Run = treads × tread depth. Diagonal = √(rise² + run²). Angle = arctan(rise ÷ run).
Worked example
A 108-inch rise with a preferred maximum 7.5-inch riser needs 15 risers. Each is 7.2 inches. With 14 treads at 10 inches, total run is 140 inches. The theoretical diagonal is 176.82 inches and the slope is about 37.65°. These dimensions still require code, headroom, landing, structural, and field review.
Assumptions and common pitfalls
- The theoretical diagonal is not an order length or structural stringer size.
- Finished floor and tread thickness details affect field layout.
- Uniform mathematical risers do not verify an existing built stair.
Frequently asked questions
Why are there fewer treads than risers?
For a conventional single straight flight ending at an upper landing, the landing acts as the final walking surface. The model therefore uses one fewer tread than riser.
Does a passing custom code check mean the stair is compliant?
No. It only compares the calculated riser and entered tread with your limits. It does not assess headroom, handrails, guardrails, landings, nosings, structure, or all local requirements.
Can I use metric dimensions?
Yes. The metric mode uses centimeters for geometry and square meters for landing area. Switching measurement systems converts numeric dimensions while retaining material prices per piece.
